Eastwood Page 386

Simichrome Polish 50gm Tube

Simichrome Polish 50gm Tube. If it's metal, or even if it's plastic, you can shine it beautifully with Simichrome Simichrome Polish shines-up everything from car mirror mounts to dull Bakelite radio trim. Many uses around your home too. Formulated in Germany to polish the... - Simichrome Polish 50gm Tube.

Single Pass Pneumatic Door Skinner Tool

Single Pass Pneumatic Door Skinner Tool. Doorskin installation has traditionally been a tedious task, done with a hammer and dolly. This tool provides a better way! Rolls over the door skin edge without ripples or other distortion. Single hand operation leaves the other hand free to hold th... - Single Pass Pneumatic Door Skinner Tool.

Skin Zipper Air Hammer Driver Door Skinning Tool

Skin Zipper Air Hammer Driver Door Skinning Tool. Designed with steel shaft and self lubricating nylon head Form and crimp at 45 degree angles Inlcudes two slot sizes for thick or thin metal skins Head skins must be replaced after ten door treatments Two side slot widths are included for thick or th... - Skin Zipper Air Hammer Driver Door Skinning Tool.

Slag Bed for CertiFlat 24 InchX48 Inch Plasma Table

Slag Bed for CertiFlat 24 InchX48 Inch Plasma Table.

Slag Bed for CertiFlat 24"X 48" Plasma Table

Slapping File Coarse Cut

Slapping File Coarse Cut. An old-time secret for removing dents and/or smoothing body work on hand fabricated panels. The serrated face works in two ways: it shrinks the stretched metal, and highlights high/low spots that require hammer and dolly work. When used as a slapping... - Slapping File Coarse Cut.

Slapping File Medium Cut

Slapping File Medium Cut.

The Medium Cut Slapping File is used to shrink stretched metal and highlight low spots.

An old-time secret for removing dents and/or smoothing body work on hand fabricated panels. The serrated face works in two ways:

... - Slapping File Medium Cut.

Small Pleated Cartridge Filter for Eastwood Dust Collector 22108

Small Pleated Cartridge Filter for Eastwood Dust Collector 22108. Keep your dust collector operating at peak efficiency. This replacement small pleated filter cartridge fits the 22108 90 CFM dual Filtration Dust Collector. Made in USA.... - Small Pleated Cartridge Filter for Eastwood Dust Collector 22108.

Soda Blast Media - Maintenance M - 50# Bags

Soda Blast Media - Maintenance M - 50# Bags.

Maintenance "M" Soda Blast Media is the basic soda to use for standard paint removal.

• Blasts-away old enamels, urethane, epoxies and lacquer coatings
• MoistureGuard 2 additive eliminates clumping, sporadic flow
• 170 Mi... - Soda Blast Media - Maintenance M - 50# Bags.

Soda Blast Media - Maintenance XL 50 Lb Bag

Soda Blast Media - Maintenance XL 50 Lb Bag.

Maintenance XL Soda Blast Media is our most aggressive soda for paint removal.

• Blasts-away heavy coatings, base/clears, epoxy primers
• MoistureGuard 2 additive eliminates clumping, sporadic flow
• 270 Micron size
<... - Soda Blast Media - Maintenance XL 50 Lb Bag.

Soft Sanders 11 in 6 pack

Soft Sanders 11 in 6 pack.

Soft Sanders 6-Pack

Soft Sanders 6-Pack.

Six blocks of three different densities vary in firmness and yet all are soft enough to be distorted or compressed into places that are hard to sand.

• Every single curve and surface on each block has been designed for a purpose

Solder Paddle P33 Round

Solder Paddle P33 Round.

Solder Paddle P33 Round made of hard rock maple for long service. Use with tallow (31016) to prevent solder from sticking and to keep the wood in top condition.

Solder Paddle P66 Flat

Solder Paddle P66 Flat.

Solder Paddle P66 Flat made of hard rock maple for long service. Use with tallow (31016) to prevent solder from sticking and to keep the wood in top condition.

Soldering Tallow 1 lb

Soldering Tallow 1 lb. A clean, efficient method for lubricating solder paddles. Just flash your torch tip in the tallow tin and put your solder paddle in the melted tallow. Keeps lead from sticking to the paddle.... - Soldering Tallow 1 lb.

SolderWeld Alloy Sol - Aluminum Repair and Joining Rods SW-AS09310

SolderWeld Alloy Sol - Aluminum Repair and Joining Rods SW-AS09310.

This Aluminum Solder rod is perfect for fabrication and all aluminum repair on body panels or tears. The solder has a 600 degree flow rate and a 30,000 PSI rating. SolderWeld SW-ASF1 Alloy Flux is needed for these rods.

SolderWeld Alloy Sol Powder Flux (1 oz.jar) SW-ASF1

SolderWeld Alloy Sol Powder Flux (1 oz.jar) SW-ASF1.

This Alloy Sol flux decibtanubates the repair area so no pre cleaning is nessasary. It works with SolderWeld SW-AS09310 Aluminum Solder Rods.

SolderWeld Multi Sol - Multi Metal Solder SW-MS09306

SolderWeld Multi Sol - Multi Metal Solder SW-MS09306.

This Multi use Metal Solder rods are great due to its low tempature flow rate of 350 degrees. It fits right in to the classic car restoration industry because it will bond with all dissimilar metals including lead! It has a PSI rating of 20,000 an... - SolderWeld Multi Sol - Multi Metal Solder SW-MS09306.

SolderWeld Sil Sol-56 Premium 56% Silver Solder (2 rods per tube) SW-SS5602

SolderWeld Sil Sol-56 Premium 56% Silver Solder (2 rods per tube) SW-SS5602.

This 56% Premium Silver Solder is perfect for Engine Blocks, Exhaust Manifolds, Cast Iron and if a perfect color match to stainless steel. It is a strong application in all dissimilar metal bonding. The Flux is pre applied on the rod for better ea... - SolderWeld Sil Sol-56 Premium 56% Silver Solder (2 rods per tube) SW-SS5602.

Solid Mig Wire 0.023in

Solid Mig Wire 0.023in. Professional grade, for Precision work, and consistent Performance

Applications

• Automotive Repair
• Farming
• Construction
• Heavy Equipment

Solid Mig Wire 0.030in

Solid Mig Wire 0.030in. Professional grade, for Precision work, and consistent Performance

Applications

• Automotive Repair
• Farming
• Construction
• Heavy Equipment